Untitled design (64)

Fios Remote Won’t Change Channels: Troubleshooting Guide

The convenience of a Fios remote control is unmatched when it comes to managing your television viewing experience. However, like any electronic device, Fios remotes can sometimes face issues that hinder their performance. One common problem is when your Fios remote won’t change channels. If you find yourself in this frustrating situation, don’t worry! This troubleshooting guide will help you get your Fios remote back in working order and your channel-surfing experience back on track.


  1. Check for Simple Solutions


Before diving into the more complex troubleshooting steps, it’s always a good idea to start with the basics. Here are a few simple solutions to try:


  1. **Replace the Batteries**: Weak or dead batteries can cause your remote to malfunction. Replace them with fresh batteries and see if the issue is resolved.


  1. **Check the Remote’s Line of Sight**: Ensure there are no obstacles between your remote and the TV. Sometimes, even minor obstructions can affect the signal.


  1. **Clean Your Remote**: Over time, dirt and dust can accumulate on the remote’s sensors. Clean your remote with a soft, lint-free cloth to ensure proper functionality.


  1. Reboot the Set-Top Box


If your Fios remote is still not changing channels, try rebooting your set-top box. Follow these steps:


  1. Unplug the power cord from the set-top box.


  1. Wait for about 30 seconds, then plug it back in.


  1. Allow the set-top box to fully reboot, which may take a few minutes.


  1. Once it’s back online, test your remote to see if it’s now changing channels.


  1. Re-Pair Your Remote


Sometimes, your Fios remote can lose its connection to the set-top box. To re-establish this connection, follow these steps:


  1. On the Fios remote, press and hold the ‘Menu’ and ‘OK’ buttons simultaneously for a few seconds.


  1. The remote’s LED light will blink, indicating that it’s in pairing mode.


  1. On your TV screen, you’ll see a message confirming that the remote has been paired.


  1. Try changing channels to see if the issue has been resolved.


  1. Reset Your Fios Remote to Factory Settings


If re-pairing doesn’t work, you can try resetting the remote to its factory settings. Keep in mind that this will erase any custom settings or programmed buttons. To reset your remote:


  1. Press and hold the ‘Menu’ and ‘AUX’ buttons until the LED light blinks twice.


  1. Enter the code ‘9-8-0.’


  1. The LED light will blink twice again, indicating that the remote has been reset.


  1. Test your remote to see if it now changes channels.


  1. Contact Customer Support


If none of the above steps resolve the issue and your Fios remote still won’t change channels, it may be time to contact Fios customer support. They can provide further guidance and assistance, and if necessary, they may arrange for a replacement remote if yours is found to be faulty.




A Fios remote that won’t change channels can be a frustrating experience, but with the right troubleshooting steps, you can often resolve the issue on your own. Always begin with the simplest solutions, like checking the batteries and ensuring a clear line of sight. If those don’t work, proceed with more advanced troubleshooting steps, including rebooting the set-top box, re-pairing the remote, or resetting it to factory settings. Remember, Fios customer support is there to help if all else fails. With these steps in mind, you can quickly get back to enjoying your favorite channels without interruption.

Leave a Reply

Your email address will not be published. Required fields are marked *